Guide
4-rib, 7-rib, 9-rib or full corrugation: how to choose
The rib pattern is the first decision on a semi-rigid aluminum duct. It sets how tight the duct bends, how far it compresses for shipping, and how much the corrugation disturbs the airflow. This page compares the four profiles we make and the jobs each one suits.
What the ribs do
Ribs are formed into the strip as the duct is spiral-wound. More ribs per metre means a more flexible wall: it bends to a smaller radius but adds slightly more friction inside. Fewer ribs give a smoother bore and a stiffer wall for long straight runs.
All four profiles are made from 8011-O aluminum strip, 0.06–0.15 mm depending on diameter and order, and are supplied in 3 m standard lengths. Custom lengths from 0.5 m to 6 m are quoted per order.
Profile comparison
| Profile | Typical diameter | Compressed from 3 m | Best for |
|---|---|---|---|
| 4-rib | 80–350 mm | about 80 cm | short connections, tight bends |
| 7-rib | 75–350 mm (small 40–100 mm) | about 90 cm | general runs, hand bending |
| 9-rib | 100–500 mm | about 75 cm | large diameters, mixed routing |
| Full corrugation | 100–500 mm | about 60 cm | maximum flexibility, container shipping |
How to pick
- Short connections at the unit — 4-rib or full corrugation; it takes the bend without kinking.
- Long straight runs with a few elbows — 7-rib; smoother bore, still hand-bendable.
- Large diameters (250–500 mm) — 9-rib, where more ribs are needed to keep the wall workable.
- Export by container — full corrugation compresses to about 60 cm per 3 m length, so the same carton holds more metres.
FAQ
Common questions
If yours is not here, send it with the size list.
Does the profile change the airflow?
Can two profiles be combined in one order?
Next step
